bushings发音

意思翻译

n.[电]套管；轴衬；支架避震组（bushing的复数形式）

相似词语短语

oiled bronze bushings───油青铜衬套

双语使用场景

Upper and lower bushings are standard for smooth valve operation.───上部和下部衬套符合流畅平稳轻松操作阀门的标准要求。

Un-housed VCA shipped as Coil Assembly and Field Assembly, without shaft and alignment bushings.───线圈，现场组装，船运不配自调整轴承和绝缘套管。

Exposed to elevated temperatures with some finishes intact or bushings installed.───暴露到恶劣的温度条件下，接触到涂层或装有衬套。

Put a little on each side of wheels and cams at the bushings and let soak down into the axles as well.───投入一点在轮子和凸轮的每边在轴衬并且让浸泡下来入轨。

Both bushings' mechanical properties can meet the work requirements, but equal thickness wall bushing is better than conventional.───两种衬套的力学性能均能满足螺杆马达的工作要求，但等壁厚衬套要优于常规衬套。

The company mainly produces seal ring, nozzles, bushings , drilling teeth, solder films, ball valves, valve seats and other products.───公司主要生产密封环、喷嘴、轴套、钻齿、钎片、阀球、阀座等产品。

Each rod pivots about a separate vertical axis through the bushings and is spring biased toward one side of the base plate.───约一个单独通过套管垂直轴杆的每个支点，正朝着一个底板侧偏的弹簧。

Do not drop or kick the master rotary bushings into position. Always use insert tools and hoist them into pastor.───不要投放或踢缩小方瓦，应该用公用工具提着放入。微型摄像头。

By the way of fixing and supporting bushing with the cylindrical fixture, the grinding of bushings in lathe can be realized.───采用套筒定位和夹持瓷套，可实现在车床上对瓷套进行磨削。

英语使用场景

If Master Bushings, Insert Bowls and slips coordinate properly, the uniform load can distribute over the most gripped place, the pipe would not be torn and worn.

Our modular control is ideal for lower-cavity applications like direct-feed bushings and smaller hot runner systems.

Therefore the bushings, bearings, cam apertognathia, needle roller bearings and other parts must be intact.

Worm wheel and gear transmission with long - life bushings, so that the machine is durable.

Through the analysis on the result of calculation a thorough discussion has been carried out on the effect of air film on the back of bush for bushings with elastic or rigid support.

Minor wear and tear in the journal, simply press out the old bushings with new bushings, and revised from time-axis in general, it can get back to the gap with the extent permitted.

Graphite impregnated "IEM" type bushings. No grease fitting required. All lifters require one bushing at top of rod clearance hole (at pocket).

Level3: Tolerance matching of freewheel bushings. Factory only.

The grooves for double Oring seals are machined in the stem sheath of protective plastic for redundant stem leakage protection in conjunction with both the upper and lower bushings.