crankshafts信息详情
曲（柄）轴（crankshaft的复数）
forging crankshafts───锻造曲轴
Crankshafts of as cast pearlite ductile iron have been produced stably by double random inoculation.───通过二次随流孕育，稳定生产铸态珠光体球铁曲轴的生产工艺。
The paper introduces the working principle in making crankshafts by using advanced tr upsetting.───本文介绍了先进的TR镦锻法制造曲轴毛坯的工作原理。
The ion nitriding of the diesel engine crankshafts was tested.───采用脉冲式离子渗氮炉对柴油机曲轴进行了辉光离子渗氮处理。
A few modern engines use cast crankshafts, made of special cast-iron containing chromium, nickel, and molybdenum.───多数现代柴油机是整体曲轴，用碳钢或含有镍、铬和钼的合金钢锻造而成。
After treatment, these crankshafts have concave surface, as well as retain minor black spots(see photo), and normal elsewhere.───经处理后，表面留有一处凹面，并有细微小黑点（请查看照片），其他地方正常。
This section describes the servicing of crankshafts, main bearings, and engine Blocks and cylinders.───本节介绍曲轴、主轴承、发动机机体和气缸的维修。
You can machine all types of crankshafts from single-cylinder to twelve cylinder crankshafts.───零件类型涵盖了从单缸到12缸的所有曲轴品种。
Crankshafts and connecting rods are not standardized.───曲轴以及连接杆都是没有标准的。
Cast iron crankshafts are satisfactory in car and light-duty truck engines.───铸铁曲轴满意在车里，轻型卡车发动机。
Based on Barkhausen Noise ( BN ), heat treatment residual stresses of crankshafts were practically measured.
Finally, the automatic balancing method of crankshafts is described, using as an example the automatic line for balancing the type QDX-1 six cylinder crankshafts.
The crankshafts shown in Fig 1-4 is actually made up of various parts such as main bearing journals, rod journal, crank arm, bearing, counter balanced weight and flywheel end.
This paper presents the experiment and investigation of automotive engine crankshafts made of 45V untempered steel.
It is quite correct in measuring the bending strength of connecting rod journal fillet of most normal structure crankshafts, but for some special structure crankshaft, it can't obtain ideal results.
Automobile and motorcycle spare parts - crankshafts, connecting rods, shafts, power steering shafts.
The distortion law of high-speed diesel crankshafts during nitriding was studied. The influence of crankshafts shape and nitriding process parameters on the distortion was analyzed.
William M. Clark, a retired businessman, generously provided a collection of engines, levers, pumps, axles, and crankshafts for us to display in boxlike frames.
Controlled by microcomputer, the entire process is full - automatic machine provides flexibility to harden various crankshafts.