side nozzle信息详情
侧喷嘴
guarder nozzle───保护喷嘴
nozzle spray───[医] 喷嘴
nozzle air───喷嘴空气
nozzle equation───喷嘴方程
nozzle valve───[动力]喷嘴阀
dredge nozzle───挖泥嘴
rinsing nozzle───清洗喷嘴（rinsing是rinse的现在分词）
nozzle brush───喷嘴刷
nozzle tip───喷嘴；油嘴
inclination angle of a side nozzle is 0, 30,45 and 60 degrees, the eddying flow of the bottom hole vortex device will cause rotation at the bottom hole, affecting on the jet from bit nozzles.───侧喷嘴倾斜角度在0度、30度、45度和60度情况下，由于井底涡旋器的旋流作用，导致井底产生旋转，对钻头喷嘴射流产生了影响，以致在45度时出现压力损失最小的情况；
The result shows that laser induced plasma and weld geometry are sensitive to side nozzle height, its inclination angle and side gas flow rate;───结果表明，侧吹喷嘴高度和侧吹流速的变化对光致等离子体行为和焊缝形貌有显著的影响；
Generally, the steel rolling furnace's service life is 3-10 years, the wrought steel chamber furnace is about 2 years, and the soaking pit side nozzle furnace's is 3-6 years.───轧钢加热炉的使用寿命一般为3 ~ 10年，锻钢室式加热炉的寿命约为2年，单侧上烧嘴均热炉的使用寿命一般为3 ~ 6年。
Enter tube side nozzle diameters───输入管程管嘴直径
Generally, the steel rolling furnace's service life is 3-10 years, the wrought steel chamber furnace is about 2 years, and the soaking pit side nozzle furnace's is 3-6 years.