stress ratio发音

意思翻译

[力]应力比

相似词语短语

stress───n.压力；强调；紧张；重要性；重读；vt.强调；使紧张；加压力于；用重音读；n.(Stress)人名；(意)斯特雷斯

ratio───n.比率，比例

alternating stress mean stress───交变应力平均应力

variation ratio───异众比率；变异比率；变速比，变速范围

shear stress───[力]剪应力；[力]剪切应力；剪应力; 切变应力; 切应力; 粘性摩擦应力

financial stress───资金紧张；财务压力

residual stress───[力]剩余应力；残余应力

M stress───M应力

proof stress───[力]弹性极限应力；试验应力；耐力；弹性极限应力，耐力，试验应力; 屈服点

双语使用场景

The influence of consolidation stress ratio on damping ratio is not distinct.───但固结应力比与有效围压应力对阻尼比之影响则较不明显。

With the increase of the stress ratio r, the threshold decreased.───随着应力比的增加，门槛值下降。

get valuable results about the effect of the stress ratio and residual stress on fatigue crack growth.───应力比，残余应力对疲劳裂纹扩展的影响方面获得了有价值的成果。

For the case of fatigue loading: (1)For a given stress ratio, the specimen seeks the SDS for the largest S_(max) to which it is subjected.───对疲劳载荷作用的情况：（1）对于给定的应力比R，试样会趋于与它所承受的S_（max）最大值相应的SDS状态。

Short-pile axial force increased, pile-soil stress ratio and the pile load distribution ratio did not change significantly.───柔性桩轴力有所增加，桩土应力比与桩的荷载分担比变化不明显。

Flexible pile axial force increases, pile-soil stress ratio and the pile load distribution ratio did not change significantly. 6.───柔性桩轴力增加，桩土应力比与桩的荷载分担比变化不明显。

However, the propagating rate of weld metal will decrease with the increase in stress ratio under dead load and constant maximum loa. . .───在静载和最大载荷一定的情况下，随应力比增大，焊缝的扩展速率降低。

It also can be observed that the dynamic strength decreases significantly as radial cyclic stress ratio increases.───随着径向循环应力比的增加，土体的动强度降低。

A modified model is presented by assuming that the relation between the stress ratio and shear strain on the SMP is hyperbolic.───通过假定空间滑动面上的应力比与剪应变之间符合双曲线关系予以修正。

英语使用场景

In addition, cyclic stress ratio and number of cyclics have remarkable effects on vertical deformation of cement-soil pile composite foundation.

As the length of upper column part increases under the same condition, the end resistance under varied cross-section decreases, but the column-soil stress ratio increases.

The traditional dilatancy equation of Cam-clay model was modified and the relativity between the phase transformation stress ratio and initial effective pressure was considered.

The iterative formulas (one load condition) of the elastic energy of structure and the stress ratio of each member are given, and its properties are also discussed.

The relation between stress ratio and span centre deflection is linear, and when the stress ratio is large, the increase of mid-span deflection by cycle index is small.

Both the numerical analysis and experimental data show that the fatigue crack propagation rate is insensitive to the stress ratio for plain stress thin specimens.

When the failure criterion is decided, the limit accumulate energy dissipation can be fitted by a formula which includes the average stress, deviator stress ratio and cyclic axial stress.

It includes the concept of stress correction coefficient, a new method to determine the stress concentration factor of mortise of a disk and a new method for correcting the stress ratio.

The smaller the stress ratio is, the larger the increase of span centre deflection by cycle index is.