maximum stress发音

意思翻译

[力]最大应力

相似词语短语

maximum───adj.最高的；最多的；最大极限的；n.[数]极大，最大限度；最大量

stress───n.压力；强调；紧张；重要性；重读；vt.强调；使紧张；加压力于；用重音读；n.(Stress)人名；(意)斯特雷斯

maximum power───[化] 最高功率；[电]最大功率；最高功率

absolute maximum───最大绝对值

maximum height───最大高度

alternating stress mean stress───交变应力平均应力

shear stress───[力]剪应力；[力]剪切应力；剪应力; 切变应力; 切应力; 粘性摩擦应力

maximum drive───最大驱动力

financial stress───资金紧张；财务压力

双语使用场景

However, this method can be very useful for a simple identification of maximum stress areas.───不过，这个方法可以非常有用的一个简单的识别的最大应力区。

The results showed that the maximum stress was located in the ground circle of the radome.───结果表明受风载荷的雷达罩的最大应力发生在截球底座的边界上。

The fatigue life was linear to the logarithmic maximum stress.───疲劳寿命与最大应力近似呈对数线性关系。

The analysis shows the maximum stress concentration coefficient of this tangential nozzle is smaller than that of its radial counterpart.───计算结果表明，该切向接管的最大应力集中系数低于相同尺寸径向接管的最大应力集中系数。

The alternation of the maximum stress region between the internal and external tube wall could led to local fatigue.───应力最大区域交替出现在传热管的内外管壁上，易导致传热管局部疲劳失效；

The maximum stress in slab surface increases with decreasing the taper ratio of crystallizer, and with increasing the slab width.───随着结晶器锥度减小和连铸坯宽度的增加，连铸坯表层最大应力增加；

Results show that the position where the maximum stress happens in FEA and the actual rupture position are the same.───计算结果显示，结构中应力响应最大值发生在筛箱短横梁处，与结构实际断裂位置一致。

It may solve the problems of maximum stress and maximum deformation of cantilever beams with variable cross section under arbitrary loads.───本文提供了一种求解变截面悬臂梁在任意载荷作用下最大正应力及最大变形的方法。

The results show that the maximum stress usually appears near the position when the tooth bears most of the load.───分析结果表明，齿根应力最大值一般出现在轮齿承受最大载荷的时刻附近。

英语使用场景

The maximum stress is on the transformer core, and the glass support plate also undertakes considerable stresses.

After 59 times of iterative computation, the optimized structure parameters were obtained. The maximum stress decreased by 33.5%.

In this paper, the maximum stress of the surface plate glass in container impacted inhorizonal direction is determined by theoretical analysis and experiments.

The maximum stress point moves to compressive stress, depended on the experimental data, when negative rake angle substituted for positive one and other cutting conditions kept fixed.

The elastic limit is the maximum stress for which the material acts elastically .

Thee elastic limit is the maximum stress for which the material acts elastically.

Fatigue limit. For fatigue, the maximum stress amplitude level below which a material can endure an essentially infinite number of stress cycles and not fail.

The results showed that the maximum stress was located in the ground circle of the radome.

Under the same load, the curve that the maximum stress of aluminum honeycomb core varies with the subtense distance and depth of honeycomb core has been gained.