pitch line发音

意思翻译

[机]节线；齿距线

相似词语短语

pitch───n.运动场地；程度；音高；推销行话；倾斜度；沥青；投球；街头摆摊处；颠簸；螺距；v.投掷；投（球）；触地；击高球；重跌；颠簸；使倾斜；确定标准；定音高；投标，推销；搭帐篷；用沥青涂；用石头铺（路）；给（麦芽汁）加酵母

media pitch───媒体推广

perfect pitch───n.音高辨别力；完全音高感，绝对音感

impregnating pitch───浸渍剂沥青

pitch diameter───层心直径，（齿轮的）节径，（螺纹的）中径；[机]节圆直径

pitch-dark───adj.漆黑的

wresting pitch───摔跤场

fever pitch───n.狂热；极度兴奋；n.高度兴奋，狂热

pitch in───投入；作出贡献；把…扔进; 做出贡献; 参与; 协力

双语使用场景

Ratings to right of heavy line are not recommended, as pitch line velocity exceeds 1000 feet per minute.───当节线速度超过每分钟1000英尺时，不推荐粗实线右侧的评级。

According to the fundamentals that pure-rolling must take place between the pitch line of hob and the pitch curve of gear workpiece, the 4 axis complicated simultaneous-control relation was obtained.───从滚刀节曲线与齿轮工件节曲线之间必须进行纯滚动出发，推导出联动关系为4个坐标的复杂联动。

In the design of noncircular chain drive, the key problem is the design of pitch line of noncircular chain wheel.───在非圆链传动的设计中，一个关键问题就是非圆链轮节曲线的设计。

Ratings to right of heavy line are not recommended, as pitch line velocity exceeds 1000 feet per minute.───当节线速度超越每分钟1000英尺时，不引荐粗实线右侧的评级。

Research on the pitch line length of chain of noncircular chain drive───非圆链轮传动链条节线长度研究

Design and Graphic Simulation about Pitch-line of Denatured Ellipse Gear───变性椭圆齿轮节曲线设计及图形仿真

Research on Subsection Cubic Spline Fit of Non-circle Gear Discrete Pitch Line───非圆齿轮离散节曲线的分段三次样条拟合研究

Application of MATLAB Cubic Spline to Non-circle Gear Discrete Pitch Line───MATLAB样条曲线在非圆齿轮离散节曲线拟合中的应用

pitch line runout and other tooth tolerances are with respect to datum A───节圆跳动和其它齿轮公差均以基准A为测量基准

英语使用场景

According to the fundamentals that pure-rolling must take place between the pitch line of hob and the pitch curve of gear workpiece, the 4 axis complicated simultaneous-control relation was obtained.

The machining path can be observed directly when simulating. The feasibility of machining can be judged by comparing pitch line.

Note:1. Ratings to right of heavy line are not recommended, as pitch line velocity exceeds 1000 feet per minute. They should be used for interpolation purposes only.

Ratings to right of heavy line are not recommended, as pitch line velocity exceeds 1000 feet per minute.

This method could not only applied to outer noncircular gear with all convex pitch line but also applied to outer noncircular gear with partial concave pitch line and inner noncircular gear.

In the design of noncircular chain drive , the key problem is the design of pitch line of noncircular chain wheel.