interference fit发音

意思翻译

过盈配合；干涉配合；紧配合

相似词语短语

fit───vt.安装；使……适应；使……合身；与……相符；adj.健康的；合适的；恰当的；准备好的；vi.符合，配合；适合；合身；n.合身；发作；痉挛；n.(Fit)人名；(捷、罗)菲特

unlawful interference───[法]非法干预

interference pattern───干涉图样；干涉图（样）

destructive interference───相消（性）干扰，破坏性干扰；[光]相消干涉，[光]相消干扰；破坏性干扰

interference engine───干扰发动机

interference colors───干涉色；干扰色

constructive interference───（全息）结构干涉，相长干涉；[物]相长干涉，结构干涉；建设性干涉

radio interference───射电干扰，无线电干扰；[通信]无线电干扰；射电干扰

fit notes───调整注释

双语使用场景

The rotor shall have an interference fit to the shaft and the rotating assembly shall be dynamically balanced to ISO 1940, G. 6.3.───定子应该通过压配合与轴结合在一起，旋转总装动态平衡应该符合ISO 1940， G.6.3标准。

To prestressed sleeve, prestressed produced through interference fit between sleeve and crack pipeline.───对预应力管道，预应力通过套管与裂纹管道过盈配合方式产生。

The interference fit between the gate and seat provides bubble tight shutoff even under the lowest pressure.───即使在最低的管线压力下，闸板与阀座之间的配合也能够实现气泡级密封功能。

Bearings with a tapered bore are always mounted with an interference fit .───带圆锥孔轴承始终以过盈配合安装。

For bearings having a tapered bore , inner rings are always mounted with an interference fit .───对于圆锥孔轴承，内圈的安装始终采用过盈配合。

The mating surface of the rod and bearing cap form a rough surface (interference fit) that eliminates the need for centering sleeves.───该杆和轴承盖形成粗糙的表面（盈），减少了对中心袖子需要交配的表面。

Interference fit is required between outer ring and housing as the load is varying in direction relative to the outer ring.───外圈与轴承座之间需要过盈配合，因为相对于外圈的负荷方向有变化。

This paper deals with designed theory and method for interference fit between plastic shaft and plastic hub.───陈述了塑料实芯轴与孔座间过盈连接的设计理论和方法。

The planet gear shafts and the axis holes of the planet gears are connected under an interference fit.───行星齿轮轴与行星齿轮的轴孔之间为过盈配合。

英语使用场景

The article analyzes the failure cause of heavy interference fit with temperature difference assembly method, and bring fundamental principles to avoid the problem in assembly technique.

The planet gear shafts and the axis holes of the planet gears are connected under an interference fit.

This work studies the maximum equivalent stress on the component and the allowable amount of interference for an interference fit based on the maximum distortion energy theory.

But the interference fit by hydro form result in the damage occurring on the contact surface.