line pressure信息详情
管路压力;输送管压力
pressure───vt.迫使;密封;使……增压;n.压力;压迫,[物]压强
line line───线条线条
hydraulic pressure───液压;水压;n.水压; 液压
pressure from───来自于……的压力
ambient pressure───环境压力,周围压力;[流]环境压力;周围压力
peer pressure───同伴压力;来自同辈的压力;同辈压力; 同侪压力; 同龄人压力
external pressure───外部压力,外压,外压力
hydrostatic pressure───流体静压(力);[流]液体静压力
downward pressure───向下压力;下向压力
System's electrical equipment and to the end of line pressure switch.───通过末端的压力开关连接到系统的电器设备。
Seat tightness achieved with torque as opposed to line pressure.───利用扭矩而不是管路压力来实现阀座的密封。
There is no recommended flow direction and it does not require line pressure to seal.───不存在推荐流向,也不需要管线压力来实现密封。
Check initial pressure to see if full intended line pressure is applied at the valve inlet.───检查初始压力,看看是否全部预设管道压力是否应用在阀门进口处。
f. The bore lube line pressure of each cylinder in a tandem pair equals suction pressure of the low-pressure cylinder in the pair.───在串连式气缸,润滑油管线压力等于低压段的进气压力。
Before the 168 IOD service project was on line, pressure test was needed to test if systems pressure burden ability is up to predicted.───移动168信息点播业务系统扩容工程上线之前,为检验其是否能够达到包括预期的负荷承受力,需要进行压力测试。
Release the paint line pressure and switch off the power before doing maintenance with the sprayer or changing accessories.───在保养喷漆枪或者更换配件之前,松开喷枪压力阀并且关闭电源。更详细。
Do not use restrictive fittings or undersized lines that can starve the Super Air Knife by causing excessive line pressure drop.───不要使用限流管件或尺寸偏小的管道,否则会因压降过大而导致??
The amount of air pressure required to close the valve depends upon the line pressure of the pipeline.───关闭阀门所要求的气压值依赖于管道内的管道压力。
There is no recommended flow direction and it does not require line pressure to seal.
Theinstrument has a high static line pressure capability of 3, 625 PSI.
Controlled closing of the valve, opens the mainline check valve, gradually increasing line pressure.
Open test cock No.1 and No.3 admitting line pressure to downstream side of second check valve.
When the line pressure to atmospheric pressure, open the ball tube, check pigging or caliper effect.
Remove the throttle cable, cruise control cable ( if equipped ) and the transmission line pressure cable.
There is no recommended flow direction - and it doesn't require line pressure to seal.
In general, 25 psi over line pressure is required for full closure.
- i willalways loveyou
- nutrition mutant
- knights hospitallers
- miss danni
- nutrition pot
- miss danger
- outage probability
- nutrition relationships
- jumper quest
- march to the decade
- move speed
- jumper stay
- in idea
- i win the
- insulating cardboard
- look out for yourself
- insulating cement
- nitrendipine
- one drop only
- m u k
- march to the door