mould plate发音

意思翻译

[塑料]模板，[木]模型板

相似词语短语

mould───n.模具，铸模；（人的）个性，类型；霉，霉菌；耕作土壤，腐殖土；n.(Mould)（美、爱、英）莫尔德（人名）；v.（用模具）浇铸，塑造；对……施加影响；将…塑造成；紧贴于，吻合（轮廓）；使长霉

mould release───分型粉

mould engineer───模具工程师

bepower mould───bepower模具

plate───n.碟；金属板；金属牌；感光底片；vt.电镀；给…装甲；n.(Plate)人名；(英、德、俄、西、意、瑞典)普拉特

injection mould───注塑模具；注射模

tie plate───系板；连接板；钢轨垫板

excussion plate───筛板

needle plate───针板；导针板

双语使用场景

Finally, the mixed control is discussed and the corresponding mould plate is proposed.───最后还讨论了混合控制方式，并提出了相应的模板。

This artical presents the productive technology and formulae of urea-formaldehyde resin used in bamboo mould plate.───本文对竹胶板模板用脲醛树脂胶的生产工艺和配方试验研究做了介绍。

The mould plate and ejector grid system is shown in chain-dotted lines in the cross-sectional view.───模板和顶料格架系统在剖面图上以点划线表示。

The problem associated with this particular gate design is with respect to the machining of the tapering curved orifice in the mould plate.───和这种特殊浇口设计相关的问题是逐渐变细的曲线孔在模板上的加工。

We stated previously that the ejector grid must provide adequate support for the mould plate.───我们前面已经说明顶料系统必须对模板提供足够的支撑。

Further movement of the moving mould plate actuates the stripper plate and the moulding is ejected.───动模板进一步的运动带动推板，使得塑件顶出。

or at least one mould plate (3) serves as a dispensable mould plate of the mould framework element;───或者至少一块模板（3）为充当模壳构件部件的一次性模板；

The Design and Application of the Movable Steel Mould Plate used in the Tunnels with Outsized Sections───特大断面隧洞钢模台车的设计和应用

Construction of Reinforced Concrete Structure Mould Plate with Curved Shape Poured on Site───曲面体现浇钢筋混凝土结构模板施工

英语使用场景

This distance can be minimized, however, by sinking the sprue bush deep into the mould plate assembly as illustrated, though Ibis necessitates using a special extension nozzle.

The ejector grid is that part of the mould which supports the mould plate and provides a space into which the ejector plate assembly can be fitted and operated.

This artical presents the productive technology and formulae of urea-formaldehyde resin used in bamboo mould plate.

On the basis of Nickel mould plate fabricated by melting photoresist and electroforming PMMA cylindrical microlens arrays are fabricated by the replication technology of static casting plastic.

Note that die length of ejector pin contact with the mould plate is kept to a minimum by incorporating a clearance diameter hole in the mould plate.