inlet temperature发音

意思翻译

入口温度；进气温度；进入温度

相似词语短语

inlet───v.引进;嵌入;插入;；n.入口，进口；插入物；水湾

temperature───n.温度；体温；气温；发烧

inlet elbow───进口弯头

inlet grove───入口槽

water inlet───进水口; 进水管；[建]进水口，吸水口

critical temperature───[物][电子]临界温度；n.临界温度

inlet definition───入口定义

inlet wildwood───入口原木

temperature outside───室外温度

双语使用场景

inlet temperature and internal temperature of exhaust catalyst for two stroke moped are tested under different vehicle driving speed.───不同车速行驶工况下对二行程轻便摩托车用尾气催化剂的入口及中心温度进行了测量与分析。

Inlet temperature distortion is one of the key factors effecting engine stability.───发动机进口温度畸变是影响发动机稳定性的关键因素之一。

For rolling dryer, the higher filling power value corresponds to downstream quickly drying way, higher inlet temperature and moisture content.───对于转筒式烘丝机，采用顺流烘丝方式，较高的来料温度和水分，较大的热风流速，可获得较高的烘丝填充力。

Whereas, the heat transfer of turbulence liquid film flow is not sensitive to liquid film inlet temperature.───湍流时，热量传递对液膜进口温度的反应不如层流敏感。

Lowest viscosity can be obtained when inlet temperature and mixing temperature are in certain range.───当进口温度和混合温度稳定在一定范围时，产品黏度最低。

Viscosity of pseudo-boehmite remains unchanged when inlet temperature is in certain range.───进口温度在一定范围时，产品黏度基本保持不变；

The effects of nozzle structure, operating pressure, solid content and inlet temperature on alumina properties are discussed.───讨论了喷嘴结构、固含量、操作压力及进口温度对微球氧化铝性能的影响。

Changing the kill fluid capacity and inlet temperature can adjust the wellbore temperature effectively.───调整泥浆排量和泥浆入口温度可以作为调节井筒温度的有效途径。

Then, based on the simulation results the influence of inlet temperature and flow rate of cooling water on the performa. . .───根据仿真结果分析了冷却水进口温度和流量的变化对废热驱动型吸收式机组的性能影响。

英语使用场景

As for the dehumidifying conditions, the condensing rate for the humid air increases with Reynolds number but decreases as the inlet temperature of cold water increases.

The wall temperature increases with a rise of inlet temperature, but changes of the wall temperature distributions of the flame tube are not obvious.

In this method, the dispersion and overall change of the cavities'frequency can be controlled by changing water flux and inlet temperature of cooling water.

It can be seen that if the engine air inlet temperature is higher and the ambient pressure is lower than the standard conditions , the power output of the effects will be lower.

In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.