inlet air temperature发音

意思翻译

进气温度

相似词语短语

air inlet───进风口；进气孔；进风口，进气口; 进气道

air temperature───[气象]气温，[气象]空气温度

inlet───v.引进;嵌入;插入;；n.入口，进口；插入物；水湾

temperature───n.温度；体温；气温；发烧

inlet elbow───进口弯头

inlet grove───入口槽

water inlet───进水口; 进水管；[建]进水口，吸水口

critical temperature───[物][电子]临界温度；n.临界温度

inlet definition───入口定义

双语使用场景

fan operates at a set speed until the inlet air temperature exceeds the lower set point (see Table 1).───空气温度不超过最低设置温度，风扇一直以设定温度转动(见表1)。

Result: the damp proof effect enhanced with the increase of inlet air temperature and the decrease of flow rate and air pressure.───结果：微囊防潮效果随着进风温度的提高、供液速度的降低、雾化气流速的降低而增强；反之则减弱。

While the effect of engine speed on the required inlet air temperature for autoignition is different for different octane Numbers.───而发动机转速对自燃所需进气温度的影响则随所用燃料辛烷值的大小而异。

One way is increasing the combustion initial temperature, and the other is reducing the gas turbine inlet air temperature.───提高燃气轮机的出力和热效率有两种方法，一种方法是提高燃烧初温，另一种方法是降低燃机进气温度。

The fan operates at a set speed until the inlet air temperature exceeds the lower set point (see Table 1).───如果环境空气温度不超过最低设置温度，风扇一直以设定温度转动（见表1）。

The fan speed will continue to increase linearly until the inlet air temperature reaches the higher set point (see Table 1).───风扇会一直线性地提高转速，一直到环境空气的温度达到最高设置温度（见表1）。

System integrators must never allow the inlet air temperature to exceed the higher set point.───系统集成商必须保证风扇周围温度永远不会超过最高设置温度。

Displacement Ventilation for Three Heat Sources: Influence of Inlet Air Temperature───送风温度对三个污染源置换通风效果影响研究

英语使用场景

The experimental study was focused on the effects of inlet air temperature, inlet air flow rate and accelerating pipe length on ISCs volumetric evaporative coefficient.

While the effect of engine speed on the required inlet air temperature for autoignition is different for different octane numbers.

The experimental results show that the ISC has a relatively high volumetric evaporative coefficient, which increases with the rising of inlet air flow rate and the rising of inlet air temperature.

With the increase of inlet air temperature of the condenser, evaporation pressure, condensation pressure increase, but supercooling and superheat degree, refrigerating capacity and COP decrease.