bridge method发音

意思翻译

桥接法

相似词语短语

bridge───vt.架桥；渡过；n.桥；桥牌；桥接器；船桥；n.(Bridge)人名；(英)布里奇

method───n.方法；条理；类函数

biffin bridge───双鳍桥

bridge over───在…上架桥; 应付，克服; 跨接；在…上架桥；渡过；暂时帮助

bridge rectifier───[电子]桥式整流；[电子]桥式整流器

eyebar bridge───眼球桥

gasometric method───气体容量法，气体定量分析法

teaching method───教学方法；教学方式

setter method───塞特法

双语使用场景

On the basis of the above models, conflicts are tackled by extension transformations and transforming bridge method.───在模型建立的基础上，运用可拓变换和转换桥等可拓学的思想与方法，对冲突问题进行处理。

Three methods on measuring high resistance improved electric bridge method, voltage method, and comparative method are introduced in the article.───三种测量高值电阻的方法：改进电桥法、电压法、比较法，并用这三种方法对同一高值电阻进行了测量。

The detection circuit uses alternating current capacitance bridge method and the principle is based on the correlated demodulation.───检测电路为基于相关检测原理的交流电容电桥的方法。

This paper briefly introduced the way which check the position of the cable short circuit spots by current bridge method.───简介用电桥法检测电缆短路点的位置。

Alternating frequency range influence on the conductivity measurements of electrolyte solutions using alternating current bridge method───交流频率对交流电桥法测定电解质溶液电导率的影响

The analysis to the electric bridge method in the measurement of the voltampere characteristic of diode───对电桥法测二极管的伏安特性的分析

Methods of measurement of value of dielectric loss tangent for power cables (high voltage alternating current bridge method)───电力电缆介质损失角正切值测量方法（交流高压电桥法）

Simple remembering monosaccharide molecular structure by using the building- bridge method───利用搭桥法简化记忆单糖分子结构

it is also introduced details in the paper for the simulation bridge method composition, working principle and measures of raising accuracy;───详细介绍了仿真电桥的构成、工作原理及提高测试精度的各种措施等；

英语使用场景

The Curie temperature and saturation magnetization of manganese-zinc ferrite were measured by using the electric bridge method, induced method and vibrating sample magnetometer (VCM).

The detection circuit uses alternating current capacitance bridge method and the principle is based on the correlated demodulation.

The principle of location of cable breakdown point by the HV bridge method is presented. The main factors affecting the location accuracy are analyzed in detail and tests are made using this method.

The measuring of self-inductance coefficient by means of direct current bridge method has reduced the difficult and improved the precision of measuring.