axial stress发音

意思翻译

[力]轴向应力；轴应力

相似词语短语

axial───adj.轴的；轴向的；n.(Axial)人名；(法)阿克西亚尔

stress───n.压力；强调；紧张；重要性；重读；vt.强调；使紧张；加压力于；用重音读；n.(Stress)人名；(意)斯特雷斯

axial force───轴线力，轴向力

axial spondyloarthritis───可考虑中轴型脊柱炎

axial fan───轴流式风机，轴流式通风机；[机]轴流式通风机；[机]轴流式风扇；轴两扇风机

axial age───轴心时代；轴心世纪

axial racing───轴向赛车

alternating stress mean stress───交变应力平均应力

shear stress───[力]剪应力；[力]剪切应力；剪应力; 切变应力; 切应力; 粘性摩擦应力

双语使用场景

According to the regulation of axial stress distribution, a way to design the rational end construction is given.───根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。

The fiber breaks into incrementally smaller fragments at locations where the fiber's axial stress reaches its tensile strength.───在纤维的轴向应力达到其强度的地方，纤维逐步破成小的碎片。

Through a lot of creep test of frozen clay under single-axial stress, the curves and parameters of creep under single-axial stress state are obtained.───通过大量的冻结粘土单轴蠕变试验，获得了单轴应力状态下的蠕变曲线及其参数。

Meanwhile, the side friction resistance and axial stress of each pile change diversely along the pile length.───同时各桩的桩侧摩阻力及桩身轴力沿桩长的变化也有所不同。

The two methods of tensioning cables are compared from three aspects: cable forces, axial stress and vertical displacements.───从索力大小、钢结构应力和竖向位移及其变化幅度等方面对比分析了两种张拉方法的优缺点。

It will decrease the maximum axial stress of the lining, but it will increase the maximum shear stress and flexural stress.───开挖引致的松动区减少围岩劲度，将减少衬砌轴向应力，但增加剪应力及挠曲应力。

This paper analyzes the meso damage process of rock using the combination of the macroscopic axial stress with the density damage increment.───采用宏观轴向应力与密度损伤增量结合分析岩石细观损伤演化过程。

The relation of hoop stress and axial stress of the shell is analyzed under axial compressive stress.───研究了受轴向压应力情况下，环向应力知轴向压缩失稳能力之间的关系。

英语使用场景

On the basis of relationship between bolt axial stress and rate of change in ultrasonic wave transmission time, the author has developed a device to directly measure axial stress in bolts.

As the cylinder descends into deeper air, axial stress increases until elastic failure occurs.

The result shows that axial stress of Pile takes on degression along with deepness and the effective length of Pile is influenced by replacement-ratio.

The results show that the axial additional strain keeps line relationship with the axial stress around the indentation. The optimization of experiment parameters is also discussed.

The axial stress in them produces a clamping force equal to the product of the proof-load stress, reduced by a design factor, and the core area of the bolt or screw.

The bending stress varies axially while the average axial stress changes a little.

Analysis and discussion was made on the influence of saddle position change on the axial stress, shearing stress and circumferential stress of the cylinder of double-saddle horizontal vessel.

When the failure criterion is decided, the limit accumulate energy dissipation can be fitted by a formula which includes the average stress, deviator stress ratio and cyclic axial stress.

The axial stress on the steel tube which appears on the contact region of the steel tube and mandril is larger than the radial and circumferential stress.