bottom side信息详情
底部
bottom───n.(Bottom)人名；(英)博顿；vi.到达底部；建立基础；vt.装底；测量深浅；查明真相；adj.底部的；n.底部；末端；臀部；尽头
at bottom───实际上（等于atthebottom）；adv.实际上; 说到底; 骨子里
bottom hole───底孔，下部孔；底孔，井底；下部孔；底部炮眼
side to side───从一边到另一边；边对边
bottom view───底视图，仰视图；[机]底视图；[机]仰视图
bottom line───n.概要，账本底线；结果；概要；账本底线；关键
SU Bottom───SU底部
river bottom───河底
bottom drawer───<美>（妇女为结婚准备的）嫁衣
Coat the bottom side of the fabric with the latex rubber.───的反面也涂满胶乳。
Can clean PCB top side surface with components mounted on the bottom side.───PC B背面贴装有元件时，另一面也可清洁。
Add fillets to pan and cook about 4 minutes until bottom side is seared.───把鱼片放的锅上煎大约4分钟，直到底部焦黄。
From the bottom side you can see tow pairs of holes for the valves and the spark plug holes nestled between them.───从下至上的球队中，你可以看到拖车对黑洞的阀门和火花塞孔坐落关系。
The tube comprising the semicircle arc plate is fixed at the bottom side and the side wall of the heating tube.───半圆弧形板构成的管道固定在底边和侧壁上。
Set in the adhesive viscoelastic, used in the production process is how you will cause a large head, the bottom side of the hemomediastinum.───而在无线胶黏订生产工艺中，采用上述操作，就会产生很大的天头、地脚破口。
This enables plug for cloth can more accurately posted to the back of the head and the bottom side of the border.───这样使堵脚布能更不确不天贴到书不面的天脚和不天脚的外沿。
If a cover design-time to set aside the bottom side of the head, burrs, and sizes, this behavior completely avoidable.───如果在封面设计时留出天头、地脚的毛边尺寸，这种现象完全可以避免的。
If you wear, will cause back head is inconsistent with the bottom side of the molding, a party that tells of a circle, and so on.───如果磨损严重，会造成书背天头地脚成型不一致，一头方一头圆等。
This paper discusses the principle of bottom side alignment system on double-faced lithography, and mainly introduces the application of digital image processing in the system.
Your task is to find the route between two given squares with the minimal sum of numbers on the bottom side.
Body: Hardcoat Anodized, precision machined mounting surface with tapped hole accessible from bottom side.
First, the bottom side of the hole in the wall, skirting board in preparation for the installation of the floor.
Figure 3 . Bottom side of a plastic stencil, showing undercut features to sit over board components.
On the one hand, this should suppress scale pick-up on the tunnel furnace rollers which may lead to so-called depressions on the slab bottom side.