burning temperature信息详情
燃烧温度
煅烧温度
temperature───n.温度;体温;气温;发烧
burning───adj.燃烧的;强烈的;发热的;v.燃烧;晒黑;以……作燃料;飞速驾驶(非正式)(burn的现在分词);n.燃烧;火;adv.炙热地;火热地
reichstag burning───国会大厦燃烧
fire burning───烧伤
critical temperature───[物][电子]临界温度;n.临界温度
burning off───烧除;烧毁
burning of───燃烧
burning bush───燃烧的灌木
burning house───燃烧的房子
The increase of the burning temperature caused the lowering of the copper extraction.───升高的燃烧温度导致了降低的萃取铜含量。
The paper discusses the computing method and computing process of theoretical burning temperature.───探讨了计算理论燃烧温度的方法及推导过程。
For diffusion burner, burning temperature is lowest, attenuation of velocity is quick.───扩散式燃烧器燃烧温度最低,速度衰减快。
The suitable burning temperature and micro morphology of the cement were studied by XRD and SEM-EDS, etc.───利用XRD,SEM-EDS等,研究了该水泥的适宜烧成温度范围和熟料的显微形貌。
Fuel oil burning temperature is 2100 degrees.───燃料油烧至2100度。
Oxygen rich blast can make gas decrease, theory burning temperature high.───富氧鼓风后引起炉缸煤气量减少,使风口前理论燃烧温度明显升高。
Study on the preparation of alite-sulfoaluminate clinker under low burning temperature with high alumina gangue and marine gypsum───利用高铝煤矸石和盐石膏低温烧制阿利特-硫铝酸盐水泥熟料的研究
Influence of cigarette smoking parameters on burning temperature and delivery levels of smoke constituents───抽吸参数对卷烟燃烧温度及主流烟气中某些化学成分的影响
For premixed burner, burning temperature is highest, combustion focuses in the interior of spout mainly, and influence of swirling jet flow on mainstream is great.
The significance in increasing theoretical hot stove burning temperature by blast furnace gas enriching and separating was expounded in this paper.
The influence of the burning temperature and the time required for maintaining the temperature on the dissolution properties of various burnt gypsums is discussed and presented in this article.
The suitable burning temperature and micro morphology of the cement XRD and SEM - EDS , etc.
Experiments doing in oxygen gases. has a burning temperature ordinary 850 degree about, Burning period 30-60 minutes, high temperature preservation 2-3 minutes.
The burning temperature of raw mix has direct relations with its burnatiliy. Under the same device conditions, using burnability index can control burning temperature of the kiln.
Raw meal with high saturation factor and high burning temperature are beneficial to the strength.
Heat decomposition temperature and initial burning temperature of SBS modified asphalt can be risen by adding compound flame-retarder.
For diffusion burner, burning temperature is lowest, attenuation of velocity is quick.
- beat up the eggs
- active trigger
- ana daniela
- apron leather
- ana de armas
- auto desk
- apron lever
- disintegrated soviet union
- active trimming
- auto desk design review
- crossland
- active trip
- auto desk recap
- ana digi
- auto detail
- detailed configuration
- active tube
- active trust
- bio block
- ana digi temp
- beat up to do