built-up edge发音

意思翻译

[机]切屑瘤

相似词语短语

built up───[机] 组合; 同“build”；确立；增进（健康）；集结（部队）

built-up───adj.组合的，拼合的；建筑物多的；以增添组件而加高

built up area───建筑面积，已建设区；建成区

built up to───加强；建造多达...；加大

edge up to───侧身走近

built───adj.有……体格的；身段优美的；……建成的；v.建造，建立；逐步增强；把……嵌入（墙壁、物体等）（build的过去式和过去分词）

edge───n.(Edge)人名；(英)埃奇；vi.缓缓移动；侧着移动；n.边缘；优势；刀刃；锋利；vt.使锐利；将…开刃；给…加上边

clipper built───剪裁器制造

built on───以…作基础

双语使用场景

An integrated dynamometer and quick-stop device is developed to investigate into some problems about built-up edge and scaling.───本文研制了一种测力—落刀装置，对积屑瘤和鳞剌的某些问题进行了试验研究。

By electronic microscope analysis, it is found that there is a certain amount of second dispersed phase in the martensite matrix which is the metallurgical factor of forming built-up edge.───通过电镜分析，发现在马氏体基体上有一定数量的弥散的第二相存在是引起积屑瘤产生的冶金因素。

Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.───带切屑瘤的连续切屑：这种切屑显示了粘合或“焊接”在刀具面上材料局部高度变形区的存在。

Furthermore, an effective cutting lubricant can reduce the surface roughness because it reduces the built-up edge.───此外，一个有效的润滑剂，可以减少切削表面粗糙度，因为它减少了重建边。

Note that soft steels can be difficult to machine, with built-up edge formation and poor surface finish.───注意，软碳钢很难机，采纳装配式边形成和可怜的外貌光洁度。

The new coating has a low friction co-efficient to minimize the risk of built-up edge and improve chip evacuation.───这种新型涂层摩擦系数小，减少了内置边缘的风险，利于排屑。

A built-up edge results in a rough surface.───结果在建筑物多边缘粗糙的表面。

Continuous chip with built-up edge───连续切屑附积屑刃口

英语使用场景

By electronic microscope analysis, it is found that there is a certain amount of second dispersed phase in the martensite matrix which is the metallurgical factor of forming built-up edge.

The new process improves toughness and chipping resistance and thus reduces friction and built-up edge.

A built-up edge that has been created on the cutting edge of the tooling.

Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.

An integrated dynamometer and quick-stop device is developed to investigate into some problems about built-up edge and scaling.

Note that soft steels can be difficult to machine, with built-up edge formation and poor surface finish.