drawing force信息详情
[机]拉伸力，[机]拉拔力；拉力
drawing───v.绘画；吸引（draw的ing形式）；拖曳；n.图画；牵引；素描术
force───n.力量；武力；军队；魄力；n.(Force)人名；(意)福尔切；(英、法)福斯；vt.促使，推动；强迫；强加
scale drawing───[测]比例图；缩小图；按原物比例画的画
headdress drawing───头饰图
still drawing───仍在绘制
eyeball drawing───眼球牵引
drawing in───（白昼）渐短；（汽车或火车）到站；穿经；收回（银行券等）
flames drawing───火焰绘图
draft drawing───草图
reduction affects drawing temperature little and its increasing lowers drawing force.───变形程度对拉伸温度影响小，变形程度的增大使拉伸力下降。
So the solution can be used to calculation of drawing force during draw-out by idle rolls.───因而，该解析解可在工程上计算圆管辊拔拔制力时推广应用。
The thinning drawing force is calculated through deforming work method and slip-line method irrespectively, and the results are compared in this paper.───本文用变形功法和滑移线法分别求解变薄拉深力，并将两种方法的计算结果进行了比较。
When the roller passes through the roving, a certain twist level can be untwisted, and thereby the drawing force is reduced.───当粗纱须条在辊轮经过时能退去一定的捻度，使牵伸力降低。
Under the same air flow, the side - lay's drawing force in the single - sheet feeding mode is stronger than in the stream feeding mode.───在同样气体流量前提下，间歇输纸的侧规拉纸力比连续输纸要大。
It is shown that steel strength can be decreased, plasticity can be increased and drawing force can be reduced by electroplastic drawing.───试验结果表明，电塑性加工技术，可有效地降低钢丝生产中的拉拔力，降低钢丝的强度，提高塑性。
This model have considered the effect of friction to well head drawing force, especially curved portion must take friction into account.───该模型在前人研究的基础上考虑了摩阻力对井口提拉载荷的影响。
Hydraulic is used to supply the deep drawing force of punch, the blank holder force and the cavity hydraulic pressure.───利用液压提供凸模拉深力、压边力以及凹模容腔压力；
In a certain range. drawing force is reducing along with the increasing of drawing speed, which was reached by test.───通过试验得出拉拔力在一定范围内是随着拉拔速度的提高而降低的。
The said experiments show that with the roll-die drawing process the drawing force can be considerably reduced and surface quality of the shape steel tube improved.
The drawing force, rational wall - thickness reduction and the characteristics of cold-draw process and equipment are analyzed.
The analyze of drawing force model is well meeting to the experimental result. Foundation is laid for optimal design of die structure and technological design of tube plug drawing mill.