deformation temperature发音

意思翻译

变形温度

相似词语短语

deformation───n.变形

temperature───n.温度；体温；气温；发烧

plastic deformation───塑性变形，柔性变形；[力]塑性变形，塑性应变

ductile deformation───延性变形；柔性变形

deformation gradient───[力]变形梯度

deformation retraction───形变收缩

deformation definition───变形定义

elastic deformation───弹性变形；[力]弹性形变

deformation geology───变形地质学

双语使用场景

Dynamic recovery and recrystallization of the composite generate with the increasing of deformation temperature.───随变形温度升高，复合材料发生动态回复再结晶。

Effect of strain rates on peak flow stress is relate to deformation temperature.───应变速率对峰值应力的影响与变形温度有关。

Thermal deformation temperature and liner expansion coefficient of the composite were decreased.───该复合材料的热变形温度有所降低，但线膨胀系数减小。

The resin toughness, the casting of the thermal deformation temperature is a good comprehensive performance winding resin.───该树脂韧性好，是一种综合性能良好的缠绕用树脂。

Deformation temperature and the deformation velocity will affect critical deformation, and thereby affect the dynamic recrystallization.───变形温度，变形速度等因素都会影响临界变形量，从而影响动态再结晶。

The results showed that the flow stress and deformed microstructure were greatly affected by strain rate and deformation temperature.───结果表明：应变速率和变形温度对合金的流变应力与变形组织有显著影响。

Within a certain range, grain size becomes small as deformation temperature declines and strain rate rises.───在一定范围内，降低变形温度提高变形速度可使动态再结晶晶粒尺寸减小，随变形程度增大，晶粒变得细小。

The results show that the flow stress decreases with the deformation temperature increasing and strain rate decreasing.───结果表明：合金的流变应力随着变形温度的升高和应变速率的降低而降低；

decreasing deformation temperature, the kinetics of phase transformation was accelerated.───随着形变温度的降低，过冷度增加，相变动力学过程加快。

英语使用场景

With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.

Coarse crystalline LC4 Aluminium Alloy presents certain superplasticity at lower deformation temperature and higher strain rate because it can create effective recrystallize refinement.

The results show that the static softening rate increases with the increase of deformation temperature and holding time, the size of grain is bigger too.

The results show that coarse crystalline LC4 Aluminium Alloy can present certain superplasticity at proper deformation temperature and velocity.

The resin produced by the flame-retardant products with high strength and mechanical properties, thermal deformation temperature, curing speed, and good soak.

The results showed that the grain boundary cohesion become weaker and intergranular fracture became dominant with the increasement of superplastic deformation temperature.