degree of hardness发音

意思翻译

硬度；偏心度

相似词语短语

hardness───n.[物]硬度；坚硬；困难；冷酷

a degree of───一定程度上的

degree───n.程度，等级；度；学位；阶层

durometer hardness───[力]计示硬度

hardness tester───硬度试验机；硬度测定仪

degree of confidence───可信度，[统计]置信度；信赖度

degree of freedom───[物]自由度

adverbs of degree───程度副词

the degree of───……的度（音阶或度数）；……的学位；……的程度

双语使用场景

The maximum degree of hardness obtainable in steel by direct hardening is determined largely by the carbon content.───直接淬火后的刚所能获得的最大硬度在很大程度上时由含碳量决定的。

Die head and blades USES the alloy material, high degree of hardness ultra wear-resisting, surpasses the overseas similar product.───模头及刀片采用合金材料，高硬度超耐磨，优于国外同类产品。

sartorius fitting's degree of hardness can reach above 60, and some even can reach above 65.───缝纫机配件硬度都可以达到60度以上，最高可以达到65度以上。

The hydrogenation can be controlled to produce any degree of hardness desired in the product .───氢在食品工业中对于所谓的氢化过程也很有用。

Even if erects again immediately, feminine bioelectricity also because penis degree of hardness will reduce, will reduce.───即使马上再勃起，女性生物电也会因为阴茎硬度降低，降低。

Tempering: tempering is a process of reducing the degree of hardness and strength and increasing the toughness.───回火：回火是减少硬度和强度并提高韧性的一种工艺。

Soft gum series: TPR: Has (degree of hardness to be allowed soft to achieve 0).───软胶系列：具有柔软（硬度可以做到0度）。

Hard chrome plating is a high degree of hardness and wear resistance and chemical stability.───软铬镀层有很矮的软度及矮度的耐磨性和化学安定性。

英语使用场景

The findings as follows: For 5BB grafts, its adult plant grew exuberantly, its germinating ratio and fruit ratio was relatively high, fruit quality fine, degree of hardness high, storable.

The hydrogenation can be controlled to produce any degree of hardness desired in the product.

SO4 grafts, its adult plant had medium growth ability, germinating rate and fruit branch rate higher, fruit degree of hardness value highest, storable, fruit quality fine, the flavor is good.

The knife board shovel cape may act according to the soil degree of hardness the difference, adjusts the knife board to be buried the angle.

The highest degree of hardness reaches 456HV at higher flame intensity. The degree of hardness is related to the scanning rate of flame but not flame intensity.

Uses in each kind of medium degree of hardness solid material , in cement industry, limestone in broken bits , paste , chamotte, and so on mix material .

The deep formation has a high degree of hardness and abrasivity; the bit type selection is difficult and the ROP is low especially under the high density mud.

These sartorius fitting's degree of hardness can reach above 60, and some can reach above 65.

If a low degree of hardness is satisfactory, through-hardening is probably the most desirable heat treatment process to be used because of its inexpensiveness .