contact arc发音

意思翻译

接触弧

相似词语短语

contact───vt.使接触，联系；n.接触，联系；vi.使接触，联系

arc───n.弧（度）；弧光（全称electricarc）；弧形物；天穹；vt.形成电弧；走弧线；n.(Arc)人名；(法)阿尔克；adj.圆弧的；反三角函数的

arc flash───电弧闪光

jerboa arc───跳鼠弧

fordo arc───福尔多弧

refract arc───折射弧

arc touch───弧光触摸

arc games───弧形游戏

unharmonious arc───不协调弧

双语使用场景

In this paper, friction field distribution between sliver and pressure bar on a homebred drawing frame is analyzed, and on this basis, the best range of contact arc is deduced.───本文以国产并条机为例，分析了并条机上须条与压力棒上摩擦力界的分布，并进一步推导出了须条对压力棒包围角度的最佳范围。

load assignment formula and the method of the double circular arc gear under the wiring error influence between the contact mark was introduced and inferred.───介绍并推导双圆弧齿轮在安装误差影响下接触迹间载荷分配的计算公式和方法。

effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.───试验模拟了切削面积、接触弧长、切削面形状、切削齿后倾角和岩石性能对PDC切削齿破岩受力的影响。

Electronic arc extinguisher - used for eliminating the contact arc on AC contact───电子灭弧器-用于消除交流接触器的触点电弧

英语使用场景

The results show that the plastic flow of the metal material nearby contact arc area towards free surface of workpiece becomes the burr under the coupling actions of the thermal and mechanics.

The valves for the coordination of control point contact arc tooth cylinder warm drive cutters and worm parameters are presented.

In this paper, friction field distribution between sliver and pressure bar on a homebred drawing frame is analyzed, and on this basis, the best range of contact arc is deduced.

It is necessary to calculate the cutting area, cutting volume, and contact arc of PDC bit cutters in bit' design and analysis.

Based in simulation, the results of the roll force in the contact arc, the friction force in the contact arc, and the relation of the contact friction and the roll force are gained.

The effects of cutting area, contact arc length, the geometry of cutting face, back dip angle of PDC cutter and rock performance on force of PDC cutter breaking rock were simulated experimentally.

This method can judge conveniently the position of the contact point of cam with follower and the radius of curvature and the position of the center of curvature of contact arc ...

The length of contact arc between the strip and rolls is calculated with boundary conditions.