chippings信息详情
n.碎片；豁口（chipping的复数）
implanted chip───植入芯片
chips tv show───chips电视节目
chip hailstone───冰雹
lastbutnomicro chip───最后一片玉米片
chip was sad───奇普很伤心
ruffles chips───荷叶边薯片
archipelagic sea lanes───群岛海道
chip wagon───切屑车
potato chips───马铃薯片；油炸薯片；n.马铃薯片; 炸土豆片( potato chip的名词复数 )
seaweeds chips───海藻片
wood chippings are showered with dirty water enriched with oxygen.───富含氧气的脏水冲刷碎木屑。
used for building or are broken down for use as an aggregate for concrete or as ballast chippings.───用于建造房屋，或将其破碎作为混凝土骨料和铺道渣。
both cases the feedstock is chippings and other leftovers from forestry and timber-mills.───这两家的原材料都是木屑或者是森林以及木材加工厂的废料。
The requirement here is that chippings exposed at the surface should help to provide adequate skidding resistance.───此处的要求是暴露于表面的碎片应该有助于提供足够的防滑阻力。
Assemble and disassemble tables and chairs with care, minimizing damage to equipment and walls, including scratches, paint chippings, etc.───小心的组装和分拆桌椅，尽可能少的给设备和墙壁造成损坏，包括划痕，漆面擦痕。
Surface dressing - Specifications - Part 3 : rate of spread and accuracy of spread of binders and chippings.───敷路料规范.第3部分：粘合剂和石屑摊铺的速度和准确度
Surface dressing - Test methods - Part 1 : rate of spread and accuracy of spread of binders and chippings.───敷路料.试验方法.第1部分：粘合剂和石屑摊铺的速度和准确度
Road construction and maintenance equipment - Chippings spreaders - Terminology and commercial specifications───道路建设和维修设备.碎片摊铺机.术语和商业规范
Surface dressing - Specifications - Rate of spread and accuracy of spread of binder and chippings───敷路料.规范.粘合剂和石屑摊铺的速度和准确度
Could this be caused by something in granite chippings which are used for drainage in the bed.
Danger! Loose chippings, eg as a warning to motorists.
To date, the limestone chippings have not yet been installed.
The wood chippings are showered with dirty water enriched with oxygen.
Loose chippings, eg as a warning to motorists.
Later, at his trial, when the many chippings were exhibited, John's fate was sealed.
Finish by sprinkling chippings and rolling them in.
Paths of bark chippings will help to give the impression of a woodland walkway.
By workpiece reaming, iron chippings emission and workpiece surface edge, which are corresponding to the vibration signal characteristics, the drill broken phenomenon will be analyzed.