test voltage发音

意思翻译

[电]测试电压；试验电压

相似词语短语

voltage limit───电压极限

input voltage───[电]输入电压；工作电压

voltage measurement───[电]电压测量

voltage source───n.电压电源

voltage regulation───稳压；[电]电压调整；[电]电压变动率；电压变动率，电压调整，稳压

doubler voltage───倍增电压

voltage difference───[电]电压差

voltage rating───[电]额定电压

voltage tester───电压检测器

双语使用场景

Diagram 1: Evolution of leakage current as a function of test voltage.───图1漏电电流随电压变化的函数图。

Note the exponential decay in the current using both a positive and a negative test voltage.───注意在使用正、负测试电压时电流的指数衰减情况。

With this method, the user enters the test voltage, measurement time and the number of iterations.───使用这个方法，用户输入测试电压、测量时间和重复次数。

The voltage rating of these resistors must be at least equal to the test voltage.───这些电阻器的电压额定值必须至少等于测试电压。

Since the voltage drop across the ammeter is negligible, essentially all the test voltage appears across R.───由于安培计上的电压降可以忽略，所以所有的测试电压都出现在电阻R上。

Shielding may also be applied to a conductor carrying a high level test voltage to prevent interference with nearby low level circuits.───承载高测试电压的导体也应该采用屏蔽，以防止与邻近的低电平电路发生干扰。

To test passive components, the tester places a test voltage across the component under test and measures the current.───在测试无源器件时，测试设备对被测试的器件施加一个测试电压后，测量电流。

As shown in Figure 2-35, the shunt capacitance (CSHUNT) must be charged to the test voltage by the current (IS).───如图2-35所示，并联电容（CSHUNT）必须由测试电流（IS）充电到测试电压。

英语使用场景

This application employs a Model 6517A Electrometer, which can supply the test voltage and measure the residual voltage.

In the paper the influences of altitude and atmosphere condition on external insulation test voltage are introduced, and the effect mechanisms are analyzed respectively.

The voltage rating of these resistors must be at least equal to the test voltage.

The resistor is first measured with test voltage V 1, giving R 1.

Note the exponential decay in the current using both a positive and a negative test voltage.

With this method, the user enters the test voltage, measurement time and the number of iterations.

Industrial frequency test voltage waveform shall be practical sine wave.

The test voltage is applied for specified period of time before the resulting current is measured.

The test voltage shall be the nominal system voltage corresponding to the ballast input voltage rating, as specified in Table 16.3.3.1.