tolerances信息详情
v.给……定公差（tolerance的第三人称单数）
n.界值，容差（tolerance的复数）
flatness tolerance───平面度公差
intolerant milk───不耐受牛奶
intolerant one crossword───不能容忍的一个填字游戏
gluten intolerance symptoms───面筋不耐症症状
intolerable pain───难以忍受的疼痛
intolerable act date───不可容忍的行动日期
tolerate synonym thesaurus───同义词库
religiously tolerant───宗教上的宽容
intolerable acts 1774───不可容忍法案1774
tolerate ambiguity───模糊容忍
safe tolerances be set for unavoidable poisonous substances.───对于不可避免的有毒物质，要设定安全耐受性限度。
Measurement will be conducted with instruments suitable for the applied tolerances.───测量应使用与符合适用公差的量具测量。
Tolerances specified in the welding specification or approved WPS shall apply.───焊接规范或认可的WPS中规定的公差应予以适用。
Machining is capable of creating geometric configurations, tolerances, and surface finishes often unobtainable by any other technique.───机加工能够达到几何形状，公差及表面精度，这些通常其他的技术都达不到。
Compliance with the tolerances and the requirements for the general condition lies within the responsibility of the manufacturer.───一般条件的容差和要求的符合性在制造商的责任中列出。
Since the usage of these bearings allows very loose tolerances, extreme trike frame alignment will not be a critical issue.───由于这些允许的用法非常宽松的公差，极端三轮车帧定位将不会是一个关键问题。
Optimal dimensional and geometric tolerances could be obtained by an appropriate optimization algorithm for the model.───求解该模型能同时得到优化的尺寸公差和形位公差。
"It is possible that the different cryptic species will have different tolerances to these chemicals, " says King.───“不同隐性物种对这些化学药品有不同的耐药性是可能的，”金说。
Much of this equipment has specific operational tolerances and requires forethought for the design and construction of its environment.───很多设备有其特殊的操作偏差，所以事先需要根据环境进行设计与建造。
Based on disease investigation, tolerances of major planting blueberry (Vaccinium spp. )species were compared.
Tolerances, gaps, surfaces, installation chamfers , length of bearing surface, length of stroke, frequency, speed, etc.
Tolerances for the engine lathe depend primarily on the skill of the operator.
All dimensions and tolerances apply in a free state condition.
Representation of tolerances is a basis for tolerance analysis and synthesis. Proposes a computer-aided representation method to represent geometric tolerances.
Unless otherwise specified, all geometric tolerances apply for full depth, length, and width of the feature.
Screw parameters in VGCN specified by tolerances in TN are expressed as inequation, which is inequation constraint in optimization of tolerance values.
It has tremendous tolerances for terrain and climate.
KEF analyzed the effect of component tolerances on the overall response and found that by tightening these in the most critical areas an improvement in consistency could be achieved.