tensile stress发音

意思翻译

n.张应力

相似词语短语

tensile───adj.[力]拉力的；可伸长的；可拉长的

stress───n.压力；强调；紧张；重要性；重读；vt.强调；使紧张；加压力于；用重音读；n.(Stress)人名；(意)斯特雷斯

tensile toughness───断裂韧性

tensile test───[力]拉力试验；抗拉试验；拉力试验，拉伸试验，抗拉试验

tensile strength───[力]抗张强度；n.抗张强度

tensile modulus───[力]拉伸模量；定伸强度；抗张模量

tensile structures───抗拉结构；拉膜结构

tensile load───拉伸负荷，拉伸载荷

alternating stress mean stress───交变应力平均应力

双语使用场景

zone of tensile stress moved to the frenal notch from the pre palate.───拉应力中区由基托前腭部移动到唇系带切迹区。

Plastic deformation concentrates at the ferrite area under the tensile stress es.───在拉应力作用下，塑性变形集中在铁素体区。

We would like to know the tensile stress in the wall.───我们很想知道壁内的拉应力。

Since the cope is usually made by flamed cutting, a high residual tensile stress exists along the burned edge.───由于修割工作通常用火焰烧割，沿着烧切边缘就存着较高的残余拉应力。

In terms of the zone under tensile stress, the existence of ventral moment is beneficial, but negative to the zone under compressive stress.───对于承受压应力的那个区而言，腹杆弯矩的存在是不利的。

SEALS. ELASTOMER BASE MASTICS USED FOR SEALING. DETERMINATION OF ADHESIVNESS-COHESION. CHARACTERISTICS UNDER TENSILE STRESS.───缝隙.密封缝隙用弹性胶泥，拉力作用下附着粘度性能测定

After the crack initiating, it propagates along the vertical direction of the tensile stress axial line.───裂纹萌生后主要沿着与拉应力轴垂直的方向扩展。

In the structural design of the windows, it should be noted that the surfaces in high tensile stress should not contact with moisture.───在舷窗结构设计时还应避免使处于张应力的表面与水分接触。

The tensile stress of trapezoid and rectangle were along the top and bottom edge of the linear distribution.───长方形、梯形拉应力均沿顶、底边线性分布。

英语使用场景

We would like to know the tensile stress in the wall.

These outside conditions include environmental temperature, voltage, tensile stress, and bending load.

But under the control of NE-SW tensile stress field of Early Cretaceous, in the eastern part of "Ergun Block" sag belt was formed and the basement tectonics is NE-NNE direction.

Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen.

The new formula for computing the allowable tensile stress given in the new specifications is not reasonable.

Research results: Under the same load condition, the tensile stress of ballastless track slabs without close connected is bigger than that of slabs with close linkage structure.

The specimen deforms under a tensile stress applied parallel to the fibres.

Tensile stress and compressive stress have different effects on the magnetic domain structure.

Figure 4 shows a plot of tensile stress versus distance from the weld for 6061, revealing curves for both T4 and T6 material in both the as-welded (AW) and post-weld-aged (PWA) conditions.