sintering temperature发音

意思翻译

烧结温度；软化温度

相似词语短语

temperature───n.温度；体温；气温；发烧

critical temperature───[物][电子]临界温度；n.临界温度

temperature outside───室外温度

temperature rise───[电]温升；温度上升；温度上升，温升，升温

constant temperature───[热]恒温；定温；等温；等温，恒温

fluctuating temperature───波动温度；脉动温度；脉动温度，波动温度

low temperature───低温，低温度；[物]低温

annealing temperature───[机]退火温度；退火点；退火点，退火温度

cpu temperature───cpu温度

双语使用场景

Effect of sintering temperature and sintering holding time on green density was analyzed.───了烧结温度和烧结保温时间对压坯密度的影响。

effect of sintering temperature on the anode porosity was investigated.───研究了烧结温度对阳极孔隙度的影响。

sintering shrinkage increased with increasing sintering temperature.───烧结温度的升高提高了烧结收缩率。

If sintering temperature could be decreased and materials consumption be reduced, life time of sintering equipment can be extended.───如果能够降低烧结温度，降低物耗，就能够提高烧结设备的使用寿命。

Pore diameter increases with the increase of the sintering temperature , which leads to a decrease in rejection rate.───孔径随着烧结温度的升高而增大，从而导致截留性能的下降；

Second, structure, morphology and electrochemical properties of the sample are closely linked with the sintering temperature.───其次，样品的结构、形貌和电化学性能都和煅烧温度有着紧密联系。

It has been found that the colour of red iron oxides in ceramics is affected by sintering temperature and the compositions of the ceramics.───本文考察了烧成温度、陶瓷坯体中常见氧化物，以及二氧化硅包裹对铁红呈色稳定性的影响。

The sintering behavior of powder and dependence of the density on sintering temperature and time have been studied.───研究了粉末的烧结特性，测定了烧结密度随烧结温度及烧结时间的变化。

Microstructure determined by both sintering temperature and high temperature holding time would influence acid corrosion resistance.───研究表明陶瓷烧结温度和保温时间均对陶瓷的显微结构有影响，进而影响陶瓷的耐酸腐蚀性能。

英语使用场景

The result shows that the sintering temperature of ceramic body is reduced, but the toughness is improved obviously on substitution of nepheline for feldspar.

And sintering temperature has an important effect on the initial permeability of Mn-Zn ferrites.

The optimal sintering temperature of SrTiO3 doped with different substances was investigated based on DIL analysis. Density of samples was measured by the Archimedes principle.

High sintering temperature and long maintaining time lead to the sufficient crystallization and the full densification, but result in the worsening of the deviation from the stoichiometry.

The sintering temperature and thermal expansion coefficient of the LSGM sample were determined using dilatometer.

The effects of sintering temperature, sintering time, sintering pressure and the magnitude of orientation magnetic field on the properties of the barium ferrite thick films were studied.

With the increase of sintering temperature, the apparent porosity of sample decreases, while bulk density, hardness and compressive strength increased.

Sintering temperature influenced hot-pressing process.

The high sintering temperature and machining cost are the two key obstacles to enlarge zirconia toughening ceramics as dental prosthetic.